Connecting Your Elionic Device to the Web

Follow these steps to connect your Elionic device to the web server and push data.

Step 1: Access the Administrator Menu

  1. Power on the Device: Ensure your Elionic device is powered on.
  2. Enter the Administrator Menu:
    • Press the menu button located at the bottom left corner of your Elionic device to open the administrator menu. 


Step 2: Configure Network Settings

  1. Navigate to Network Settings:
    • In the administrator menu, go to the "Network" option.
  2. Access the Web Server Settings:
    • From the Network section, click on "WEB SERVER".
  3. Enable Push Mode:
    • Make sure that "Enable Push Mode" is turned on. This will allow your device to push data to the specified server.

Step 3: Configure Web Server URL or IP Address

  1. Enter the Web Server Details:
    • If you're pushing information to an affiliated web account, enter the following details:
      • Web Server URL: 3735.us
      • Web Server IP: 209.50.60.75
      • Port Number: 80 (For Elionic 310, use port 443).
    • If you are pushing information to your own client/server, enter the appropriate server IP address for your network.

Step 4: Testing the Connection

  1. Verify Data Push:
    • After saving, verify that the Elionic device is successfully pushing by clicking Test Connection

Additional Notes:

  • Troubleshooting:

    • If the device does not push data correctly, double-check the server URL, IP, and port settings to ensure they match the required configuration.
    • Make sure your device has a stable network connection to the internet.

  • Security:

    • If you're using port 443, ensure that the server and device are configured to support secure communications (SSL/TLS).